NETGEAR M4300 User Manual

Configure Switching Information
241
M4300 Series and M4300-96X Fully Managed Switches User Manual
4. Click the Login button.
The System Information page displays.
5. Select Switching> Multicast > IGMP Snooping > Querier Configuration.
6. Use Querier Admin Mode
to select the administrative mode for IGMP snooping for the
switch.
The default is Disable.
7. In the Snooping Querier IP Address field, type an IP address.
This specifies the snooping querier address to be used as the source address in periodic
IGMP queries. This address is used when no address is configured on the VLAN on
which query is being sent.
8. Use IGMP Version to specify the IGMP protocol version used in periodic IGMP queries.
The range is 1 to 2.
The default value is 2.
9. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the snooping querier.
The query Interval must be a value in the range of 1 and 1800.
The default value is 60.
10. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last querier information is removed.
The querier expiry Interval must be a value in the range of 60 and 300. The default value
is 125.
11. Click the Apply button.
Your settings are saved.
The page displays the VLAN IDs enabled for IGMP snooping querier.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)