Configure Switching Information
247
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use VLAN ID to set the VLAN IDs for which MLD snooping is enabled.
7. Use Fast Leave Admin Mode
to enable or disable the MLD snooping Fast Leave Mode for
the specified VLAN ID.
8. Use Group Membership Interval to set the value for group membership interval of MLD
snooping for the specified VLAN ID.
The valid range is (Maximum Response Time + 1) to 3600.
9. Use Maximum Response T
ime to set the value for the maximum response time of MLD
snooping for the specified VLAN ID.
The valid range is 1 to (Group Membership Interval –1). Its value must be less than group
membership interval value.
10. Use Multicast Router Expiry Time
to set the value for the multicast router expiry time of
MLD Snooping for the specified VLAN ID.
The valid range is 0 to 3600.
11. Select the Proxy Querier Mode for the specified VLAN ID from the menu.
If you select Disable, then MLD proxy query with source IP 0::0 is not sent in response to
an MLD leave packet.
The default value is Enable.
12. Click Add
to enable MLD Snooping on the specified VLAN.
13. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
