Configure Switching Information
253
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use MVR Running to Enable or Disable the MVR feature.
The factory default is Disable.
7. Use MVR Multicast VLAN to specify the VLAN on which MVR multicast data is
received.
All source ports belong to this VLAN. The value can be set in a range of 1 to 4093. The
default value is 1.
8. Use MVR Global Query Response T
ime to set the maximum time to wait for the IGMP
reports membership on a receiver port.
This time applies only to receiver-port leave processing. When an IGMP query is sent
from a receiver port, the switch waits for the default or configured MVR query time for an
IGMP group membership report before removing the port from the multicast group
membership.
The value is equal to the tenths of a second.
The range is from 1 to 100
tenths. The factory default is 5 tenths or one-half.
9. Use MVR Mode to specify the MVR mode of operation.
Possible values are compatible or dynamic. The factory default is compatible.
10. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Table 90. MVR Configuration
Field Definition
MVR Max Multicast Groups The maximum number of multicast groups that MVR supports.
MVR Current Multicast Groups Displays current number of the MVR groups allocated.
To Next Page
Loading...
