Routing
327
M4300 Series and M4300-96X Fully Managed Switches User Manual
5. Select Routing> ARP > Advanced > ARP Create.
6. Use IP Address to enter the IP address to add.
It must be the IP address of a device on a subnet attached to one of the switch's existing
routing interfaces.
7. Use MAC Address to specify the unicast MAC address of the device.
Enter the address as six 2-digit hexadecimal numbers separated by colons, for example,
00:06:29:32:81:40.
8. Click the Add button.
The static ARP entry is added to the switch.
9. Click the Apply button.
Your settings are saved.
The pagination navigation menu functions as follows:
- Rows per page. Select how many table entries are displayed per page. Possible
values are 20, 50, 100, 200, and
All. If you select
All, the browser might be slow to
display the information.
- <. Display the previous page of the table data entries.
- >. Display the next page of the table data entries.
The following table describes the nonconfigurable information displayed on the page.
Table 117. ARP Cache
Field Description
IP Address The IP address. It must be the IP address of a device on a subnet
attached to one of the switch's existing routing interfaces.
Port The associated unit/slot/port of the connection.
MAC Address The unicast MAC address of the device. The address is six two-digit
hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.
To Next Page
Loading...
