NETGEAR M4300 - Page 331

Routing
331
M4300 Series and M4300-96X Fully Managed Switches User Manual
The login window opens.
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing > RIP >
Advanced > RIP Configuration.
6. Select the RIP Admin Mode Disable
or Enable radio button.
If you select Enable, RIP is activated for the switch. By default, RIP is enabled.
7. Select a Split Horizon Mode radio button:
• None. No special processing for this case.
• Simple. A route is not included in updates sent to the router from which it was
learned.
The default is Simple.
• Poison Reverse. A route is included in updates sent to the router from which it was
learned, but the metric is set to infinity
.
Split horizon is a technique for avoiding problems caused by including routes in updates
sent to the router from which the route was originally learned
8. In the Auto Summary Mode field, select the Enable or Disable option.
If you select Enable, groups of adjacent routes are summarized into single entries reduce
the total number of entries. The default is Disable.
9. In the
Host Routes Accept Mode field, select the Enable or Disable option.
If you select Enable, the router accepts host routes. The default is Enable.
10. In the Default Information Originate field, select to Enable or Disable default route
advertisement.
11. In the Default Metric field, specify a default value for the metric of redistributed routes.