Configure System Information
37
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Define the following fields:
• System Name. Enter the name to identify this switch. Y
ou can use up to 255
alphanumeric characters. The factory default is blank.
• System Location. Enter the location of this switch. Y
ou can use up to 255
alphanumeric characters. The factory default is blank.
• System Contact. Enter the contact person for this switch. Y
ou can use up to 255
alphanumeric characters. The factory default is blank.
• Login Timeout. Specify how many minutes of inactivity can occur on a serial port
connection before the switch closes the connection. Enter a number between 0 and
160 minutes.
The factory default is 5. Entering 0 disables the time-out.
• Management Source Interface. Select the management interface that is used as
source interface for SNMP trap, syslog, DNS, T
ACACS+, RADIUS, sflow, and SNTP
applications. Possible values are as follows:
- None
- Routing Interface
- Routing VLAN
- Routing Loopback Interface
- Service Port
- Different. For some applications from the list, the source interface is configured
separately
.
They display in the list only if this is the case.
By default VLAN 1 is used as the source interface.
7. Click the Apply button.
Your settings are saved.
The following table describes the status information in the Application Information and
System Information sections on the page.
Table 6. Application Information and System Information
Field Description
Application Information
App Name The name of the application that functions as the Universal Plug and
Play (UPnP) agent.
App Status The status of the application.
Version The version of the application.
System Information
Product Name The product name of this switch.
IPv4 Management Address The IPv4 address and mask assigned to the management VLAN
interface.
To Next Page
Loading...
