Multicast Routing
447
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use one of the following methods to select an interface:
• In the Go To Interface field, enter the interface in the unit/slot/port format and click on
the
Go button.
• Next to the Interface column, select the check box for the interface that you want to
configure.
7. In the Admin Mode field, select Enable or Disable.
This sets the administrative status of MLD on the selected routing interface. The default is
Disable.
8. In the V
ersion field, enter the version to configure for the selected interface.
V
alid values are 1 to 2. The default value is 2.
9. In the Query Interval field, enter the frequency in seconds at which MLD host-query
packets are to be transmitted on this interface.
Valid values are 1 to 3600. The default value is 125.
10. In the Query Max Response T
ime field, enter the maximum query response time, in
milliseconds, to be advertised in MLDv2 queries on this interface.
V
alid values are 0 to 65535. The default value is 10000 milliseconds.
11. In the Startup Query Interval field, enter the configured interval in seconds between
general queries sent by a querier on startup.
The default value is 31.
12. Enter the Startup Query Count value to indicate the configured number of queries sent out
on startup, separated by the startup query interval.
The default value is 2.
13. In the Last Member Query Interval field, enter the last member query interval in
milliseconds.
This is the maximum response time to be inserted into group-specific queries sent in
response to leave group messages, and is also the amount of time between
group-specific query messages. V
alid values are from 0 to 655355.
The default value is
1000 milliseconds.
14. In the Last Member Query Count field, enter the number of queries to be sent on receiving
a leave group report.
Valid values are from 1 to 20. The default value is 2.
To Next Page
Loading...
