NETGEAR M4300 - Page 514

Manage Device Security
514
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the SSH Admin Mode Disable or Enable radio button.
This enables or disables the SSH server administrative mode. When this mode is
enabled, the device can be accessed by using an SSH client on a remote system. The
currently configured value is displayed.
The default value is Disable.
7. Select the SSH Version 1
Disable or Enable radio button.
This enables or disables Protocol Level 1 for SSH. When Enable is selected, the SSH
server on the device can accept connections from an SSH client using Protocol Level 1
for SSH (SSH-1). When Disable is selected, the device does not allow connections from
clients using the SSH-1 protocol.
The currently configured value is displayed.
The default
value is Enable.
8. Select the SSH Version 2
Disable or Enable radio button.
This enables or disables Protocol Level 2 for SSH. When Enable is selected, the SSH
server on the device can accept connections from an SSH client using Protocol Level 2
for SSH (SSH-2). When Disable is selected, the device does not allow connections from
clients using the SSH-2 protocol.The currently configured value is displayed.
The default
value is Enable.
9. Use SSH Session Timeout
to configure the SSH session inactivity time-out value for
incoming SSH sessions to the switch.
A connected user that does not exhibit any SSH activity for this amount of time is
automatically disconnected from the device. The acceptable range for this field is 1-5
minutes.
10. Use Maximum Number of SSH Sessions
to configure the maximum number of inbound
SSH sessions that can be connected to the device simultaneously.
The currently configured value is displayed.
The acceptable range for this field is 0–5.
11. Use Login Authentication List to select an authentication list.
This list is used to authenticate users who try to login to the switch.