Manage Device Security
522
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Next to Allow new telnet sessions, select the Disable or Enable radio button.
This specifies whether the new outbound Telnet session is enabled or disabled. The
default value is Enabled so that new outbound T
elnet sessions can be established until
there are no more sessions available. If it is disabled, no new outbound Telnet sessions
are established. An established session remains active until the session is ended or an
abnormal network error ends the session.
7. In the Session T
imeout
field, specify how many minutes of inactivity occur on an inbound
Telnet session before the session is logged off.
You can enter any number from 1 to 160. The factory default is 5 minutes.
8. In the Maximum Number of Sessions field, specify how many simultaneous inbound
Telnet sessions are allowed.
The maximum is 5, which is also the factory default.
9. Click the Apply
button.
Your settings are saved.
The Current Number of Sessions field displays the number of current outbound
T
elnet
sessions.
To Next Page
Loading...
