Manage Device Security
576
M4300 Series and M4300-96X Fully Managed Switches User Manual
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Security > Control > Captive Portal > CP Global Configuration.
6. Select the
Admin Mode
Disable or Enable radio button.
This sets the administrative mode of the captive portal feature. By default CP is disabled.
7. In the Additional HTTP Port field, enter a port number between 0–65535 (excluding port
80).
HTTP traffic uses standard port 80, but you can use the Additional HTTP Port field to
configure an additional port for HTTP traf
fic. Enter 0 to unconfigure the additional HTTP
port.
The default is 0.
8. In the Additional HTTP Secure Port field, enter a port number between 0–65535
(excluding port 443).
HTTP Secure traffic uses standard port 443, but you can configure an additional port for
HTTP Secure traffic using the Additional HTTP Secure Port field. Enter 0 to unconfigure
the additional HTTP Secure port. The default is 0.
9. Use the Authentication Timeout field to enter the number of seconds that captive portal
keeps the authentication session open with a client that is attempting to access the network
through a portal.
T
o access the network through a portal, the client must first enter authentication
information on an authentication web page. When the time-out expires, the switch
To Next Page
Loading...
