NETGEAR M4300 - Page 593

Manage Device Security
593
M4300 Series and M4300-96X Fully Managed Switches User Manual
This field cannot be set if a mirror interface is already configured for the ACL rule.
12. Use Match Every to specify an indication to match every Layer 2 MAC packet.
Valid values are as follows:
• T
rue. Signifies that every packet is considered to match the selected
ACL rule.
• False. Signifies that it is not mandatory for every packet to match the selected ACL
rule.
13. Use CoS
to specify the 802.1p user priority to compare against an Ethernet frame.
Valid range of values is 0 to 7.
14. Use Destination MAC to specify the destination MAC address to compare against an
Ethernet frame. V
alid format is xx:xx:xx:xx:xx:xx.
The BPDU keyword can be specified using a destination MAC address of
01:80:C2:xx:xx:xx.
15. Use Destination MAC Mask
to specify the destination MAC address mask specifying which
bits in the destination MAC to compare against an Ethernet frame.
Valid format is xx:xx:xx:xx:xx:xx. The BPDU keyword can be specified using a destination
MAC mask of 00:00:00:ff:f
f:ff.
16. Use EtherType Key to specify the EtherType value to compare against an Ethernet frame.
Valid values are as follows:
• Appletalk
• ARP
• IBM SNA
• IPv4
• IPv6
• IPX
• MPLS multicast
• MPLS unicast
• NetBIOS
• Novell
• PPPoE
• Reverse ARP
• User V
alue
17. Use EtherType User V
alue to specify the user defined customized EtherType value to be
used when you selected User Value as EtherType key, to compare against an Ethernet
frame.
Valid range of values is 0x0600 to 0xFFFF.
18. Use Source MAC to specify the source MAC address to compare against an Ethernet
frame.