Configure System Information
61
M4300 Series and M4300-96X Fully Managed Switches User Manual
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv4 Management Interface
Configuration.
6. Use the Interface list to select the interface for which IPv4 parameters or management
interface can be changed.
7. When you select the Set Management Interface option, it means that the management
interface must be configured based on the interface selected.
By default, this option is not selected.
8. Select the Configuration Method DHCP or Manual radio button.
9. Specify the IP Address of the interface and the subnet mask for the management interface.
This is also referred to as the subnet/network mask, and defines the portion of the
interface’
s IP address that is used to identify the attached network.
The factory default
value is 169.254.100.100.
10. In the Subnet Mask field, specify the IP subnet mask for the interface.
The factory default value is 255.255.0.0.
11. In the Gateway field, specify the default gateway for the management interface.
The default value is 0.0.0.0.
To Next Page
Loading...
