Monitor the System
635
M4300 Series and M4300-96X Fully Managed Switches User Manual
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Monitoring > Logs > Syslog Configuration.
The Status field displays whether the host was configure to be actively logging or not.
6. Select the
Admin Status
Disable or Enable radio button.
This enables or disables logging to configured syslog hosts. When the Admin Status is
disabled, the device does not relay logs to syslog hosts, and no messages are sent to
any collectors or relays. When the syslog Admin Status is enabled, messages are sent to
configured collectors or relays using the values configured for each collector or relay
.
7. Use Local UDP Port to specify the port on the local host from which syslog messages are
sent. The range is 1 to 65535.
The default port is 514.
8. Specify the Source Interface to use for syslog.
Possible values are as follows:
• None. When the None value is displayed, it means that the configured routing
interface has become nonrouting.
• Routing interface
• Routing VLAN
• Routing loopback interface
• T
unnel interface
• Service port
To Next Page
Loading...
