Configure System Information
72
M4300 Series and M4300-96X Fully Managed Switches User Manual
requesting order follows the lexicographical ordering of the entries in this table. The valid
range is 1 to 3. The default value is 1.
10. Specify the NTP Version running on the server.
The range is 1 to 4. The default value is 4.
11. Click the Add button.
The SNTP server entry is added.
12. Repeat the previous steps to add additional SNTP servers.
You can configure up to three SNTP servers.
13. Click the Apply button.
Your settings are saved.
14. T
o change the settings, remove an SNTP server, or refresh the page, do the following:
• Change the settings. T
o change the settings for an existing SNTP server, select the
check box next to the configured server, enter new values in the available fields, and
click the Apply button.
Your settings are saved.
• Remove an SNTP server. T
o remove an SNTP server entry, select the check box
next to the configured server to remove, and then click the Delete button.
The entry is removed, and the device is updated.
• Refresh the page.
T
o refresh the page, click the Update button.
The SNTP Server Status table displays status information about the SNTP servers
configured on your switch. The following table displays SNTP Server Status information.
Table 20. SNTP Server Status
Field Description
Address All the existing server addresses. If no server configuration exists, a
message saying No SNTP server exists flashes on the page.
Last Update Time The local date and time (UTC) that the response from this server was
used to update the system clock.
Last Attempt Time The local date and time (UTC) that this SNTP server was last queried.
To Next Page
Loading...
