NETGEAR M4300 User Manual

Configure System Information
94
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Select the Admin Mode Disable or Enable radio button.
This specifies whether the DHCP service is enabled or disabled. The default value is
Disable.
7. Use Ping Packet Count to specify the number of packets a server sends to a pool address
to check for duplication as part of a ping operation.
The default value is 2. Valid range is 0, 2 to 10. Setting the value to 0 disables the
function.
8. Select the Conflict Logging mode Disable or Enable radio button.
This specifies whether conflict logging on a DHCP server is to be enabled or disabled.
The default value is Enable.
9. Select the BootP Automatic
mode
Disable or Enable radio button.
This specifies whether BootP for dynamic pools is to be enabled or disabled. The default
value is Disable.
10. To exclude addresses, do the following:
a. In the
IP Range From field, enter the lowest address in the range or a single address
to be excluded.
b. In the IP Range T
o
field, to exclude a range, enter the highest address in the range.
To exclude a single address, enter the same IP address as specified in the IP
Range From field, or leave it as 0.0.0.0.
11. Click the Add button.
The exclude addresses are added to the switch
12. Click the Apply button.
Your settings are saved.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)