Remote Control Commands
R&S
®
SMW200A
1072User Manual 1175.6632.02 ─ 16
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 7.6.2.1, "Correlating Parameters in Sweep Mode",
on page 467
Parameters:
<Points> integer
Range: 2 to POINts
Increment: 1
*RST: 100
Example: See Example "Setup an LF sweep" on page 1061.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace <State>
Activates that the signal changes to the start frequency value while it is waiting for the
next trigger event.
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Manual operation: See "Retrace" on page 479
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?
Queries the current status of the LF frequency sweep mode.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Setup an LF sweep" on page 1061.
Usage: Query only
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe <Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example "Setup an LF sweep" on page 1061.
Manual operation: See " Shape " on page 479
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
Selects linear or logarithmic sweep spacing.
SOURce Subsystem
To Next Page
Loading...
