Rohde & Schwarz SMW200A - List Mode Settings

Configuring the Signal in the RF Domain
R&S
®
SMW200A
481User Manual 1175.6632.02 ─ 16
7.6.6 List Mode Settings
The "List Mode" dialog contains all the functions and settings for creating and handling
lists with RF frequency/level pairs for generating the RF signal based on these values.
Access:
► Select "RF" > "Sweep/List" > "List mode".
The dialog contains parameters for configuring the list mode processing, entering
list mode data and transferring data files from or to the instrument.
The remote commands required to define these settings are described in Chap-
ter 13.18.11, "SOURce:LIST Subsystem", on page 1073.
● General Settings................................................................................................... 481
● List Mode Data Settings........................................................................................483
● Import/Export Settings...........................................................................................485
7.6.6.1 General Settings
Access:
► Select "RF" > "Sweep/List" > "List mode".
In the "General" tab, you can configure the trigger and dwell time modes for list
processing and activate signal generation.
Varying the RF Signal in List or Sweep Mode