Rohde & Schwarz SMW200A - Source Subsystem

Remote Control Commands
R&S
®
SMW200A
856User Manual 1175.6632.02 ─ 16
13.18 SOURce Subsystem
The SOURce subsystem contains the commands for configuring the digital and analog
signals.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
ENTity<ch>
1 to 4 Entity in a multiple entity configuration
SOURce<hw>
[1] to 8 Baseband signals/paths
●
SOURce[1] = Path A/Baseband A
(optional keyword and suffix)
●
SOURce2 = Path B/Baseband B
(mandatory keyword and suffix)
●
LF output = SOURce:LFOutput
(SOURce is optional keyword)
OUTPut<ch>
[1] to 3 Available markers
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
See also Chapter 13.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 767.
● Connector Settings................................................................................................856
● SOURce:BBIN Subsystem....................................................................................864
● Analog Modulation Subsystems............................................................................870
● SOURce:BB Subsystem....................................................................................... 886
● SOURce:CORRection Subsystem......................................................................1026
● SOURce:FREQuency Subsystem.......................................................................1037
● SOURce:INPut Subsystem................................................................................. 1047
● SOURce:IQ Subsystem...................................................................................... 1048
● SOURce:IQ:OUTPut Subsystem........................................................................ 1051
● SOURce:LFOutput Subsystem........................................................................... 1061
● SOURce:LIST Subsystem...................................................................................1073
● SOURce:NOISe Subsystem............................................................................... 1088
● SOURce:PGEN Subsystem................................................................................1089
● SOURce:PHASe Subsystem.............................................................................. 1091
● SOURce:POWer Subsystem.............................................................................. 1092
● SOURce:ROSCillator Subsystem....................................................................... 1103
● SOURce:SWEep Subsystem..............................................................................1106
13.18.1 Connector Settings
This section summarizes the commands of the OUTPut and INPut subsystems, nec-
essary to configure the local and global connectors settings. Listed are the commands
for configuring the output signals and the inputs for trigger, data, and control signals.
SOURce Subsystem