Network Operation and Remote Control
R&S
®
SMW200A
760User Manual 1175.6632.02 ─ 16
Example:
Figure 12-7: Example of a network configuration for remote operation with a smart device
As shown in the figure, the R&S SMW and the WLAN router are connected to the LAN
router. The smart device accesses the Rohde & Schwarz instrument via the WLAN
router.
Prerequisites
For this network configuration, the following prerequisites must be met:
●
The required equipment is:
– A LAN router
– A WLAN router (hot spot)
Required for accessing the R&S SMW
●
The smart device must be known and accepted in the network of the R&S SMW.
●
The App or web browser implements the VNC functionality on the smart device for
remote operation.
It is recommended that all components in the network use DHCP, which automatically
assigns the relevant address information.
With the configuration in the example, you can reach the instrument from a great dis-
tance, since the WLAN router acts as an additional access point.
12.17.2.1 Using a VNC App
Using a VNC App enables the smart device to access the R&S SMW via WLAN.
How to Set Up Remote Operation via VNC
To Next Page
Loading...
