Rohde & Schwarz SMW200A - Graphics Configuration Settings

Monitoring Signal Characteristics
R&S
®
SMW200A
568User Manual 1175.6632.02 ─ 16
8.1.3 Graphics Configuration Settings
This section focuses on the graphics configuration dialog, which determines the num-
ber and kind of the graphical signal displays.
Access:
1. Select "Taskbar > System Config > Graphics" or use the wave icon.
The "Graphics Configuration" dialog opens.
Figure 8-8: Graphics configuration dialog
2. To determine the kind of signal display, use the parameter "Mode".
3. To select suitable signal acquisition points, use the parameter "Source".
4. To enable the graphical signal display, select "Add".
A thumbnail of the graphical signal display is shown in the taskbar.
Displaying Baseband Signal Characteristics in Real-Time