Rohde & Schwarz SMW200A - Instrument Emulations Settings

Network Operation and Remote Control
R&S
®
SMW200A
720User Manual 1175.6632.02 ─ 16
Baud Rate
Sets the baudrate for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:BAUD on page 1128
Parity
Sets the parity for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:PARity on page 1128
Stop Bits
Sets the number of stop bits for the serial remote control interface.
Remote command:
:SYSTem:COMMunicate:SERial:SBITs on page 1128
12.4.5 Instrument Emulations Settings
Access:
► Select "System Config > Remote Access > Instrument Emulations".
The "Instrument Emulations" dialog enables you to emulate a remote control com-
mand set of another signal generator.
Remote Access Settings