Rohde & Schwarz SMW200A - Trigger Subsystem

Remote Control Commands
R&S
®
SMW200A
1146User Manual 1175.6632.02 ─ 16
:TEST<hw>:DIRect:BLOCk:WRITe <BoardName>, <SubAddress>, <StartAddress>,
<DataBlock>
Direct mode for programming the blocks of the hardware assemblies directly.
The respective hardware assembly responds directly to the command; any safety
mechanisms are bypassed. This function is only available via remote control.
Setting parameters:
<BoardName> string
<Board>, <SubAddr>, <Addr>, <Data>
<SubAddress> integer
<StartAddress> integer
<DataBlock> string
Example:
TEST:DIR:BLOC:WRIT 'TEST_SCPI',0,0,#1812345678
Usage: Setting only
:TEST<hw>:ALL:STARt
Usage:
Event
Starts the selftest. Use the command :TEST<hw>:ALL:RESult? to query the result.
:TEST<hw>:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with :TEST<hw>:ALL:
STARt.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST: STOPped
Usage: Query only
13.22 TRIGger Subsystem
The TRIGger system contains the commands for selecting the trigger source for the
RF and LF sweep.
You can work with an internal or with an externally applied trigger signal. In this case,
use the commands in the SOURce:INPut subsystem to configure the signal.
The trigger system of the R&S SMW is a simplified implementation of the SCPI trigger
system. The TRIGger system differs from the SCPI system as follows:
●
No INITiate command; the instrument behaves as if INITiate:CONTinuous
ON were set.
TRIGger Subsystem