Remote Control Commands
R&S
®
SMW200A
1037User Manual 1175.6632.02 ─ 16
Parameters:
<FreqRespOptBwMo>AUTO | MANual
*RST: AUTO
Example: See Example "Enabling high-quality optimization" on page 1036.
Manual operation: See "Optimization Bandwidth" on page 423
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth[:VALue]
<FreqRespOptBwVa>
Sets the signal compensation bandwidth for [:SOURce<hw>]:CORRection:
FRESponse:RF:OPTimization:BANDwidth:MODE MAN.
Parameters:
<FreqRespOptBwVa>float
Example: See Example "Enabling high-quality optimization" on page 1036.
Manual operation: See "Bandwidth" on page 423
13.18.6 SOURce:FREQuency Subsystem
The SOURce:FREQuency subsystem contains the commands used to define the fre-
quency settings for the RF sources and sweeps.
Example: Frequency configuration
SOURce1:FREQuency:MODE CW
SOURce1:FREQuency:CW 6000000000
SOURce1:FREQuency:OFFSet 2000000000
SOURce1:FREQuency:MULTiplier 1.5
SOURce1:FREQuency:CW?
// 11000000000
// SOURce1:FREQuency:STEP:MODE USER
// SOURce1:FREQuency:STEP:INCRement 1000000
// SOURce1:FREQuency:CW UP
SOURce1:PHASe 2
SOURce1:PHASe:REFerence
SOURce Subsystem
To Next Page
Loading...
