Rohde & Schwarz SMW200A - Page 1051

Remote Control Commands
R&S
®
SMW200A
1036User Manual 1175.6632.02 ─ 16
Example: Enabling high-quality optimization
SOURce1:CORRection:FRESponse:RF:OPTimization:MODE QHIG
SOURce1:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE AUTO
SOURce1:CORRection:FRESponse:RF:OPTimization:BANDwidth:VALue?
// 160000000
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE................................. 1036
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE................1036
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth[:VALue]..............1037
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
<FreqRespOptMode>
Sets the optimization mode.
The value selected here is used also as optimization mode in the I/Q modulator, and
vice versa.
For details, see R&S SMW User Manual.
Parameters:
<FreqRespOptMode> FAST | QHIGh | QHTable
FAST
Optimization by compensation for I/Q skew.
QHTable
Enabled if R&S SZU is connected to the R&S SMW and the con-
nection is active.
Improved optimization by maintained speed.
QHIGh
Optimization by compensation for I/Q skew and frequency
response correction.
This mode interrupts the RF signal. Do not use it in combination
with the uninterrupted level settings and strictly monotone
modes RF level modes
*RST:
QHIGh / QHTable (if R&S SZU connected to
R&S SMW and the connection is active)
Example: See Example "Enabling high-quality optimization" on page 1036.
Manual operation: See "Optimization Mode" on page 421
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE
<FreqRespOptBwMo>
For [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
QHIG|QHT, sets how the signal bandwidth is estimated: automatically or manually with
the command [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:
BANDwidth[:VALue].
SOURce Subsystem