Configuring the Signal in the RF Domain
R&S
®
SMW200A
551User Manual 1175.6632.02 ─ 16
7.8.4.4 NRP Info Update
The "NRP Info/Update" dialog covers information on connected power sensors, like
serial number, revision state and features of the particular sensor. You can directly
update the sensor firmware.
Access:
► Select "System Config > Setup > Instrument Assembly > NRP Info/Update".
The "NRP Info/Update" dialog indicates the connected R&S NRP sensors with spe-
cific information and contains the functions to update the firmware of a connected
sensor.
The remote commands required to configure the display and keyboard are descri-
bed in Chapter 13.16, "SENSe, READ, INITiate and SLISt Subsystems",
on page 812.
Settings
Current Sensors..........................................................................................................551
Update.........................................................................................................................551
Current Sensors
Shows the sensors that are connected to the R&S SMW with information on serial
number, the revision state, and some characteristic features.
Remote command:
:SENSe<ch>[:POWer]:TYPE? on page 824
:SENSe<ch>[:POWer]:SVERsion? on page 824
:SENSe<ch>[:POWer]:SNUMber? on page 823
Update
Provides all functions needed to run the sensor update.
Note: Download the required update file before you start the update.
Follow the instructions in Chapter 7.8.4.5, "How to Update the Sensor Firmware",
on page 552.
Improving Level Performance
To Next Page
Loading...
