Rohde & Schwarz SMW200A - Rear Panel Tour

Getting Started
R&S
®
SMW200A
60User Manual 1175.6632.02 ─ 16
Table 2-7: Overview of RF connector types depending on the frequency range
Required option Connector type
RF A: R&S SMW-B103/-B106
RF B: R&S SMW-B203/-B206
N female
RF A: R&S SMW-B112
RF B: R&S SMW-B212
Test port adapter, PC 3.5 mm female
RF A: R&S SMW-B120
RF B: R&S SMW-B220
Test port adapter, PC 3.5 mm female
RF: R&S SMW-B131/-B140/-B140N Test port adapter, PC 2.92 mm female
NOTICE! Risk of RF connector and cable damage. If you tighten the connectors too
strongly, you can damage the cables and connectors. If you do not tighten the connec-
tors enough, the measurement results can be inaccurate.
Always use an appropriate torque wrench suitable for this type of connector and apply
the torque specified in the application note 1MA99.
If your instrument is equipped with a test port adapter, refer also to 1MA100.
The application notes are available on the Internet and provide additional information
on care and handling of RF connectors.
Rohde & Schwarz offers appropriate torque wrenches for various connectors. For
ordering information, see the R&S SMW data sheet or product brochure.
2.2.2 Rear Panel Tour
This section provides an overview of the connectors on the rear panel of the instru-
ment. For technical data of the connectors, refer to the data sheet.
1
2
4
5
6
7
8
3
9
10 11 12 13 14
21
16
17a
18 19
20a
16 16 16
17a
17b
20b
15
BBMM
17b
22
Figure 2-3: Rear panel view of instrument equipped with R&S
SMW-B10 and R&S SMW-B13T (stan-
dard baseband)
Instrument Tour