Rohde & Schwarz SMW200A - Generating Signals According to Digital Standards

Configuring the Internal Baseband Source
R&S
®
SMW200A
224User Manual 1175.6632.02 ─ 16
The designation "Digital I/Q In" indicates that the instrument uses the external digi-
tal baseband signal, see Chapter 3.6, "Digital Baseband Input Settings",
on page 170.
For information, see:
● Chapter 4.6, "Generating Custom Digital Modulated Signals", on page 264
● Chapter 4.7, "Using the Arbitrary Waveform Generator (ARB)", on page 300
● Chapter 4.10, "Generating Multi-Carrier Continuous Wave Signal",
on page 372
● The description of the digital standards
● Chapter 4.12, "Shifting and Boosting the Baseband Signal", on page 382
4.4 Generating Signals According to Digital Standards
The R&S SMW generates digital signals in accordance with the specifications of the
main communication and radio standards only if the corresponding firmware options
are installed.
This section lists the supported standard-compliant digital signals, that run on the stan-
dard baseband generator (option R&S SMW-B10).
The following standards do not run on the wideband baseband generator (option
R&S SMW-B9):
●
"IEEE 802.16 WiMAX
TM
" on page 226
●
"NFC/EMV" on page 226
GSM/EDGE, EDGE Evolution
This digital standard requires an instrument equipped with the GSM/EDGE and EDGE
Evolution options R&S SMW-K40/-K41.
The GSM/EDGE, EDGE Evolution options provide functionality to generate signals in
accordance with the GSM/EDGE standard, based on the GMSK and 8PSK modulation,
and in accordance with the EDGE Evolution standard with simulation of higher order
modulations.
For details, see the R&S SMW GSM/EDGE user manual.
Bluetooth
®
Enhanced Data Rate/Low Energy
This digital standard requires an instrument equipped with the options Bluetooth
®
Enhanced Data Rate and Bluetooth
®
5.0 R&S SMW-K60/-K117.
The Bluetooth
®
options provides functionality to generate signals in accordance with
the Bluetooth Specification 5.0+EDR and the latest Bluetooth Low Energy specifica-
tion.
For details, see the R&S SMW Bluetooth EDR user manual.
Generating Signals According to Digital Standards