Configuring the Signal in the RF Domain
R&S
®
SMW200A
444User Manual 1175.6632.02 ─ 16
Figure 7-5: Synchronizing a subsequent instrument an externally applied reference frequency of
5, 10, or 13 MHz
Settings:
– Source: "External"
– External Reference Frequency: "5, 10 or 13 MHz"
REF OUT and REF IN connectors are located at the rear panel, see Chapter 2.2.2.1,
"Connectors", on page 62.
7.4.1 Reference Oscillator Settings
Access:
► Select one of the following:
● "RF" > "RF Frequency" > "Reference Freq/LO Coupling ..."
Reference Oscillator
To Next Page
Loading...
