Rohde & Schwarz SMW200A - Internal Resources for the Trigger, Marker, Clock and Control Signals

General Instrument Functions
R&S
®
SMW200A
664User Manual 1175.6632.02 ─ 16
T/M/C status LEDs
For quick overview of the source (internal/external) of the used trigger, marker and
clock signals, the block diagram displays T/M/C status LEDs on the left side of each
"Baseband" block.
If the corresponding baseband generator is active, the displayed information is color
coded, where:
●
A green LED indicates that an external signal is used
●
A yellow LED confirms that the signal is available at the output connector
The display of the letter "A" or "B" indicates that the internal signal of other baseband
source is used. The icon indicates that common trigger settings are applied.
T/E/L/P/V status LEDs
For quick overview of the source (internal/external) of the control signals, the block dia-
gram displays T/E/L/P/V status LEDs on the top/bottom of the "RF" blocks.
If the corresponding RF block is active, the displayed information is color coded,
where:
●
A green LED indicates that an external signal is used
●
A yellow LED confirms that the signal is available at the output connector
11.2.2.5 Internal Resources for the Trigger, Marker, Clock and Control Signals
Apparently, not all trigger, marker, clock and control signals can be output or input at
the same time. The Figure 11-1 is a graphical representation of the available internal
resources concerning the trigger, marker, clock and control signals. The diagram focu-
ses on the internal signals routing rather than showing the exact input and output sig-
nals.
Configuring the Local and Global Connectors