Rohde & Schwarz SMW200A - Clock Settings

Remote Control Commands
R&S
®
SMW200A
912User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay <Delay>
Defines the delay between the signal on the marker outputs and the start of the signal,
expressed in terms of symbols.
Parameters:
<Delay> float
Range: 0 to 16777215
Increment: 0.001
*RST: 0
Example: See Example "Adjusting clock, marker and trigger settings"
on page 892
Manual operation: See "Marker x Delay" on page 260
Clock Settings
[:SOURce<hw>]:BB:DM:CLOCk:MODE <Mode>
Sets the type of externally supplied clock.
Parameters:
<Mode> SYMBol
*RST: SYMBol
Example: See Example "Adjusting clock, marker and trigger settings"
on page 892
Options: R&S SMW-B10
Manual operation: See "Clock Mode" on page 261
[:SOURce<hw>]:BB:DM:CLOCk:SOURce <Source>
Selects the clock source:
●
INTernal: Internal clock reference
●
ELCLock: External local clock
●
EXTernal = ELCLock: Setting only
Provided for backward compatibility with other Rohde & Schwarz signal generators
Parameters:
<Source> INTernal | ELCLock | EXTernal
*RST: INTernal
Example: See Example "Adjusting clock, marker and trigger settings"
on page 892
Options: ELCLock requires R&S SMW-B10
Manual operation: See "Clock Source" on page 260
SOURce Subsystem