Rohde & Schwarz SMW200A - Carrier Graph

Configuring the Internal Baseband Source
R&S
®
SMW200A
369User Manual 1175.6632.02 ─ 16
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay[:STARt]
on page 953
Delay Step
Sets the step width that is used to increment the delay
The resulting delay in the carrier table equals:
Delay =
"Delay Start" + n*"Delay Step",
Where n is a value between 0 and ("Carrier Stop" - "Carrier Start").
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:DELay:STEP
on page 952
Input Waveform File
Accesses the standard "File Select" function for selecting the input file. The input file
contains the I/Q signal to be modulated ontoall carriers of the selected carrier range.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:FILE on page 953
Apply Assistant Settings
Transfers the assistant settings to the carrier table.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:EDIT:CARRier:EXECute
on page 953
4.9.3.4 Carrier Graph
Access:
1. Select "Baseband > ARB > General > Multi Carrier".
Generating Multi-Carrier Signals