Rohde & Schwarz SMW200A - Control and Marker Lists Editor

Configuring the Internal Baseband Source
R&S
®
SMW200A
282User Manual 1175.6632.02 ─ 16
Save
Stores the changes into the selected data list file.
4.6.3.8 Control and Marker Lists Editor
The R&S SMW provides the following ways to create a file containing control signals:
●
To use the tag-oriented format and create a control list file, see "To create a control
list using tag file format" on page 980
●
To use SCPI commands and create a file in binary format, see "To create a control
list in binary format" on page 980
●
To use the dedicated "Control Data Editor" and create a file in ASCII format and
with extension *.dm_iqc.
The "Control Data Editor" is described in this section. Refer to "To create a control
list in ASCII format manually" on page 286 for step-by-step instructions.
To access the "Control Data Editor":
1. Select "Baseband > Custom Dig Mod > Data Source".
2. Select "Select Control List".
3. Navigate to the required directory, for example /var/user/.
Select "New".
4. In the "Filename" field, enter the name of the new control list, for example
dl_3gpp.
5. Select "Edit".
The dedicated internal "Control Data Editor" is an intuitive graphical interface provi-
ded for defining and managing of:
● Marker signals
● Control signals, like the CW, "Hop", "Burst Gate", and "Lev_Att" control signals
Generating Custom Digital Modulated Signals