Maintenance
R&S
®
SMW200A
1167User Manual 1175.6632.02 ─ 16
Execute Baseband Selftest
Performs a baseband selftest.
The result (succeeded or failed) is displayed in the status field on the right.
Remote command:
:TEST:BASeband? on page 1142
Log Message
Displays the log message reported during the baseband test.
Remote command:
n.a.
14.3.7 FPGA/uC Update Settings
Access:
► Select "System Config > Setup > Maintenance > FPGA/µC Update".
This dialog enables you to update the PCI-FPGA.
FPGA/µC
Updates the FPGA/µC.
Remote command:
n.a.
14.3.8 Requesting Instrument Configuration and Specifications
The R&S SMW is equipped with various hardware and software components. To get
an overview of what your instrument is equipped with, you can request the assemblies,
hardware and software options, and the firmware version. The components are struc-
tured according to the hardware configuration, software options, including the license
management, and externally used Rohde & Schwarz equipment, like R&S NRP power
sensors.
Performing Maintenance Tasks
To Next Page
Loading...
