Rohde & Schwarz SMW200A - Data Source; Trigger, Marker and Clock Setting

Configuring the Internal Baseband Source
R&S
®
SMW200A
268User Manual 1175.6632.02 ─ 16
Power Ramp Control
Accesses the power ramp control dialog, see Chapter 4.6.3.6, "Power Ramp Control
Settings", on page 277.
4.6.3.2 Trigger, Marker and Clock Setting
These tabs provide standard settings.
For detailed description, see:
●
Chapter 4.5.2.1, "Trigger Settings", on page 253
●
Chapter 4.5.2.2, "Marker Settings", on page 258
●
Chapter 4.5.2.3, "Clock Settings", on page 260
●
Chapter 4.5.2.4, "Local and Global Connector Settings", on page 261
4.6.3.3 Data Source
Access:
► Select "Baseband > Custom Dig Mod > Data Source".
This tab provides access to the settings necessary to select and configure the data
source, like access to data and list editors or direct selection of PRBS data.
For an overview of the supported data sources, refer to Chapter 4.5.1.1, "Data, Clock
and Control Signals and Sources in the Baseband", on page 227.
To access the extern serial data settings
Use a standard baseband generator (R&S SMW-B10).
Provide the external serial data and clock signals at the connectors listed in Table 4-3.
1. In the "Custom Digital Modulation > Data Source" dialog, select "Data Source >
External".
Generating Custom Digital Modulated Signals