Rohde & Schwarz SMW200A - Selftest Connections Settings

Maintenance
R&S
®
SMW200A
1163User Manual 1175.6632.02 ─ 16
Remote command:
:CALibration<hw>:DEBug on page 791
Save Cal Data to File...
Opens the standard file select dialog to store the calibration data in a file.
This function is password-protected. Unlock the protection level 1 to access it, see
"Protection Level/Password" on page 688.
14.3.4 Selftest Connections Settings
Access:
► Select "System Config > Setup > Maintenance > Selftest > Connections".
The "Connections" dialog contains the parameters for testing the signal flow at the
connectors.
The remote commands required to define these settings are described in Chap-
ter 13.21, "TEST Subsystem", on page 1141.
How to set up the instrument for BNC connections tests
1. This function is password-protected. Unlock the protection level 1 to access it, see
"Protection Level/Password" on page 688.
2. Select "System Config > Setup > Maintenance > Selftest > Connections".
3. Select the BNC Source (signal output).
4. Select the BNC Destination (signal input).
Performing Maintenance Tasks