Rohde & Schwarz SMW200A - How to Verify the Generated Signal with the Graphics Display

Monitoring Signal Characteristics
R&S
®
SMW200A
574User Manual 1175.6632.02 ─ 16
See "Reference trace" on page 567.
"Ref Curves Table"
Lists the configured reference curves and their current state.
To change a curve, select it.
"Name"
Enters the name of a new reference curve
"Assign Data"
Accesses the standard "File Select" function to load a file describing a
reference curve
"Show Curve"
Toggles the show/hide state of the selected curve
"Delete"
Removes the curve
8.1.5 How to Verify the Generated Signal with the Graphics Display
This section shows you how to use the different graphic modes to visualize the signal
characteristics of the generated signal. It shows also how to observe the effect of stan-
dard settings, like applied filter, an enabled fading or AWGN. The examples use a sim-
ple custom digital modulated signal.
To generate a simple WCDMA-3GPP (QPSK 45° offset) signal
► Use the custom digital modulation. Enable a predefined WCDMA-3GPP signal.
Displaying Baseband Signal Characteristics in Real-Time