Configuring the Internal Baseband Source
R&S
®
SMW200A
330User Manual 1175.6632.02 ─ 16
●
The triangle on the top line denotes a trigger event. A filled triangle on the bottom
line denotes a next segment event.
●
A green sine wave (or other shape) over a full period indicates one replay cycle of
a segment. A shorter example signal indicates a replay cycle which was interrup-
ted, e.g. due to a next segment event (compare the two graphics in Table 4-21).
Table 4-21: Trigger examples in the "ARB" dialog
"Next Segment Mode = Next Segment" "Next Segment Mode = Next Segment Seamless"
4.8.3 Multi-Segment Settings
Access:
1. Select "Baseband > ARB > General > Create Multi Segment".
The "ARB: Multi Segment" dialog enables direct assignment of waveforms to the
multiple segments, adjusting the clock, level, and marker settings of the composed
waveform and selecting the output file.
For description on the provided settings, refer to:
Chapter 4.8.3.1, "Setting for Handling the Multi-Segment Files and Output File Set-
tings", on page 331,
Chapter 4.8.3.2, "Segment Table", on page 333 and
Chapter 4.8.3.3, "Level / Clock / Marker Settings", on page 335
2. Select "ARB: Multi Segment > General" > "Create and Load Output File" to store
and load current multi-segment file.
3. Select "Multi Segment" > "Sequencing List" to access the settings for configuring
a sequencing "Play List" for fast automatic processing of the multi-segment wave-
form.
For a description of the provided settings, refer to Chapter 4.8.3.4, "Multi-Segment
Waveform Sequencing", on page 337.
Generating Multi-Segment Waveform Files
To Next Page
Loading...
