Rohde & Schwarz SMW200A - AM, FM and Phim Modulation Sources

Configuring the Signal in the RF Domain
R&S
®
SMW200A
503User Manual 1175.6632.02 ─ 16
7.7.3.1 AM, FM and PhiM Modulation Sources
Access:
► Select "RF > Analog Modulation > Modulation Source...".
Figure 7-19: Analog Modulation > Sources
In the "Sources" tab, you can configure an LF modulation signal for performing
analog modulations. It includes the setting parameters of the internal LF-and multi-
function generators, the noise generator, and an external signal source.
To select an external signal, you can directly access the settings of the Connectors
dialog.
The remote commands required to define these settings are described in Chap-
ter 13.18.10, "SOURce:LFOutput Subsystem", on page 1061.
LF Generator
The "LF Generator" settings section contains all parameters required to configure the
signal of the internal LF Generator.
Analog Modulations