Signal Routing and System Configuration
R&S
®
SMW200A
170User Manual 1175.6632.02 ─ 16
Signal Routing
(requires R&S SMW-B10)
Defines the way the baseband signal (internally generated or externally provided) is
routed in the instrument. When routing more than one signals to the same path, the
signals are summed.
"Route to path A"
The internal or external baseband signal is routed to path A.
"Route to path B"
The internal or external baseband signal is routed to path B.
"Route to path A and B"
The internal or external baseband signal is routed to both paths.
Remote command:
[:SOURce<hw>]:BB:ROUTe on page 888
[:SOURce<hw>]:BBIN:ROUTe on page 888
3.6 Digital Baseband Input Settings
The R&S SMW provides interfaces to feed an external digital baseband signal into
the signal path.
Required Options
The equipment layout for applying an external baseband signal includes
●
Option Baseband Generator (R&S SMW-B10) per required input
(incl. one digital interfaces per installed option)
●
Up to two options Fading simulator (R&S SMW-B14)
(incl. one digital interfaces per installed option)
For exact information, refer to the instrument specification (data sheet).
Digital Baseband Input Settings
To Next Page
Loading...
