Remote Control Commands
R&S
®
SMW200A
888User Manual 1175.6632.02 ─ 16
Parameters:
<POffset> float
Range: 0 to 359.9
Increment: 0.01
*RST: 0
Default unit: DEG
Example:
BB:POFF 0.5DEG
Sets a relative phase offset of 0.5 DEG for the baseband signal
Manual operation: See "Phase Offset" on page 386
[:SOURce<hw>]:BB:PGAin <PGain>
[:SOURce<hw>]:BBIN:PGAin <PGain>
Sets the relative gain for the internal or external baseband signal compared with the
signals of the other baseband sources.
Parameters:
<PGain> float
Range: -50 to 50
Increment: 1E-3
*RST: 0
Default unit: dB
Example:
BBIN:PGA 3dB
Sets the relative gain of 3 dB for the external baseband signal.
Manual operation: See "Gain" on page 387
[:SOURce<hw>]:BB:ROUTe <Route>
[:SOURce<hw>]:BBIN:ROUTe <Route>
Selects the signal route for the internal/external baseband signal. The internal and
external signals are summed if necessary.
Parameters:
<Route> A | B | AB
Example:
BBIN:ROUT A
The external baseband signal is introduced into path A.
Options: R&S SMW-B10
Manual operation: See "Signal Routing" on page 170
[:SOURce<hw>]:BB:CODer:MODE <Mode>
Defines the source of the baseband generator.
SOURce Subsystem
To Next Page
Loading...
