Rohde & Schwarz SMW200A - Page 902

Remote Control Commands
R&S
®
SMW200A
887User Manual 1175.6632.02 ─ 16
Table 13-3: Value ranges of the suffixes ENTity<ch> and SOURce<hw> in advanced configuration
with multiple entities
SCPI Syntax
ENTity<ch> SOURce<hw>
SOURce<hw>:BB:...
- 1 .. 8
ENTity<ch>:SOURce<hw>:BB:...
1 .. 8 1 .. 4
See also Chapter 13.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 767.
The following commands are available:
[:SOURce<hw>]:BBIN:FOFFset.......................................................................................887
[:SOURce<hw>]:BB:FOFFset..........................................................................................887
[:SOURce<hw>]:BB:POFFset..........................................................................................887
[:SOURce<hw>]:BB:PGAin............................................................................................. 888
[:SOURce<hw>]:BBIN:PGAin.......................................................................................... 888
[:SOURce<hw>]:BB:ROUTe............................................................................................888
[:SOURce<hw>]:BBIN:ROUTe.........................................................................................888
[:SOURce<hw>]:BB:CODer:MODE..................................................................................888
[:SOURce<hw>]:BB:POWer:PEAK?.................................................................................889
[:SOURce<hw>]:BB:CFACtor?........................................................................................ 889
[:SOURce<hw>]:BB:POWer:RMS?.................................................................................. 889
[:SOURce<hw>]:BBIN:FOFFset <FOffset>
[:SOURce<hw>]:BB:FOFFset <FOffset>
Sets a frequency offset for the internal/external baseband signal. The offset affects the
generated baseband signal.
Parameters:
<FOffset> float
Range: depends on the installed options, e.g. -60 MHz to
+60 MHz (R&S SMW-B10)
Increment: 0.01
*RST: 0
Default unit: Hz
Example:
BB:FOFF 2MHZ
Sets a frequency offset of 2 MHz.
Options: BBIN:FOFFset requires R&S SMW-B10
Manual operation: See "Frequency Offset" on page 386
[:SOURce<hw>]:BB:POFFset <POffset>
Sets the relative phase offset for the selected baseband signal compared to the base-
band signals of the other baseband sources (second path or external baseband).
SOURce Subsystem