Rohde & Schwarz SMW200A - Source:bb Subsystem

Remote Control Commands
R&S
®
SMW200A
886User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:PULM:WIDTh <Width>
Sets the width of the generated pulse, that means the pulse length. It must be at least
20ns less than the set pulse period.
Parameters:
<Width> float
Range: 20E-9 to 100
Increment: 10E-9
*RST: 2E-6
Example: See Example "Perform pulse modulation" on page 881.
Manual operation: See "Pulse Width" on page 516
[:SOURce<hw>]:PULM:DOUBle:STATe
<State>
Provided for backward compatibility with former Rohde & Schwarz signal generators.
Works like the command [:SOURce<hw>]:PULM:MODE DOUBle.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
13.18.4 SOURce:BB Subsystem
This subsystem contains all commands for digital signal generation. It is divided into
several subsystems which are described separately.
● SOURce:BB Subsystem General Commands...................................................... 886
● SOURce:BB:DM Subsystem.................................................................................890
● SOURce:BB:ARBitrary Subsystem.......................................................................919
● Waveform, Data and List Format.......................................................................... 961
● SOURce:BB:MCCW Subsystem...........................................................................983
● SOURce:AWGN Subsystem...............................................................................1001
● SOURce:BB:IMPairment Subsystem..................................................................1011
● SOURce:BB:GRAPhics Subsystem....................................................................1015
● SOURce:BB:MEASurement Subsystem.............................................................1019
● SOURce:BB:PROGress Subsystem General Commands..................................1024
13.18.4.1 SOURce:BB Subsystem General Commands
The following section describes the commands for setting the frequency shift and the
phase offset for the signal at the output of the "Baseband" and "BB Input" blocks.
Suffixes in the keywords ENTity<ch> and SOURce<hw>
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
SOURce Subsystem