Signal Routing and System Configuration
R&S
®
SMW200A
151User Manual 1175.6632.02 ─ 16
The dialog lists the connectors, required for the current "Fading and Baseband Config-
uration".
See also:
●
Chapter 3.3.1, "Physical Location of the Input and Output Interfaces", on page 130
●
Chapter 3.4.1, "Fading and Baseband Configuration Settings", on page 138
Direction
Displays the connector direction as a color coded field, where:
●
The direction is determined by the selected "Fading and Baseband Configuration".
●
The color is determined by the configuration in the "I/Q Stream Mapping" dialog.
The following table gives an overview of the possible combinations and explains the
used designations.
Connector Direction/
Color
Enabled in the "Fading and Base-
band Configuration"
Enabled in the "I/Q
Stream Mapping"
CODER Yes -
Input
Gray
Not used -
FADER Yes -
Yes Yes
Yes Not used
Not used Not used
BBMM Yes Yes
Yes Not used
I/Q Yes Yes
Yes Not used
System Configuration Settings
To Next Page
Loading...
