Rohde & Schwarz SMW200A - Settings: State

Configuring the Internal Baseband Source
R&S
®
SMW200A
307User Manual 1175.6632.02 ─ 16
Settings:
State............................................................................................................................307
Set To Default............................................................................................................. 308
Use one Waveform for all basebands.........................................................................308
Waveforms table......................................................................................................... 308
Load Waveform/File....................................................................................................308
Waveform Info.............................................................................................................309
Clock Frequency......................................................................................................... 309
Delay...........................................................................................................................309
Create Multi Segment................................................................................................. 309
Create Multi Carrier.....................................................................................................310
Create Test Signal...................................................................................................... 310
State
Enables/disables ARB modulation. Switching on the ARB generator turns off all the
other digital standards and digital modulation types in the same signal path.
The output is based on the waveform file that is loaded. The name of the waveform file
is displayed next to "Load Waveform". When a multi-segment waveform is loaded, the
display expands and lists more settings, grouped in the "Multi Segment Waveform
Options" section.
Note: No or empty waveform file.
If no waveform file is loaded, as in the default state, "None" is displayed next to "Load
Waveform" and the ARB modulator cannot be powered up. An error message indicates
that no or empty waveform file is selected.
If no waveform file is loaded, the ARB modulator remains off. Select a waveform file,
before switching on the ARB.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:STATe on page 928
Using the Arbitrary Waveform Generator (ARB)