Rohde & Schwarz SMW200A - UNIT Subsystem

Remote Control Commands
R&S
®
SMW200A
1149User Manual 1175.6632.02 ─ 16
Effective in the following configuration:
●
TRIG:FSW|LFFS|PSW|[:SWE]:SOUR SING
●
SOUR:SWE:FREQ|POW:MODE AUTO or SOUR:LFO:SWE:[FREQ:]MODE AUTO
Alternativelly, you can use the IMMediate command instead of the respective
SWEep:[FREQ:]|POW:EXECute command.
Example:
TRIG
Starts all active sweeps.
Usage: Event
Manual operation: See " Execute Single Sweep " on page 477
:TRIGger<hw>:LFFSweep
Executes an LF frequency sweep in the following configuration:
●
TRIG:LFFS:SOUR SING
●
LFO:SWE:MODE AUTO
Example:
LFO:SWE:MODE AUTO
TRIG:LFFS:SOUR SING
TRIG:LFFSweep
Usage: Event
13.23 UNIT Subsystem
The UNIT subsystem is used to set default units for parameters if no unit is indicated in
a command. These settings are valid for the entire instrument.
Example: Setting default units for remote control
UNIT:POW V
UNIT:ANGL DEG
UNIT:VEL KMH
Sets V (volts) as unit of all power parameters, DEG (degrees) for the phase modulation
angle and KMH for the speed.
:UNIT:ANGLe.............................................................................................................. 1149
:UNIT:POWer.............................................................................................................. 1150
:UNIT:VELocity............................................................................................................ 1150
:UNIT:ANGLe <Angle>
Sets the default unit for phase modulation angle. The command affects no other
parameters, such as RF phase, or the manual control or display.
UNIT Subsystem