Rohde & Schwarz SMW200A - Show Connector

Signal Routing and System Configuration
R&S
®
SMW200A
162User Manual 1175.6632.02 ─ 16
Mode
You can send a single command ("Command") or a command sequence ("Sequence")
to the connected instrument.
Command, Send Command
Entry field for the SCPI commands.
You can enter a new command or select a previously sent command from the "His-
tory".
If the remote connection is active, select "Send Command" to execute the command.
Remote command:
:SCONfiguration:EXTernal:CODer<ch>:REMote:SEND on page 854
:SCONfiguration:EXTernal:BBMM<ch>:REMote:SEND on page 855
:SCONfiguration:EXTernal:FADer<ch>:REMote:SEND on page 854
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:SEND on page 855
File, Sequence, Send Sequence
Accesses the standard "File Select" dialog for loading of user-defined files with exten-
sion *.iec.
The provided navigation possibilities in the dialog are self-explanatory.
When a file is selected, its name and content are displayed, and the first command is
selected. You can send the commands one by one ("Send Command") or send the
entire sequence at once ("Send Sequence").
After a command is sent, the next command form the sequence is selected.
See also:
●
"To create a remote control sequence or modify the initialization sequence"
on page 207
●
"Initialization Sequence" on page 159
●
Chapter 10.5.1, "File Select Settings", on page 635.
History, Clear History
List of the sent commands.
As long as this history list is not cleared ("Clear History"), you can select a command
from the list and send it again.
Commands Trace, Clear Trace
List of the sent commands and their results, where the results are displayed in blue
color.
To delete the trace, select "Clear Trace".
Show Connector
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
System Configuration Settings