File and Data Management
R&S
®
SMW200A
632User Manual 1175.6632.02 ─ 16
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:STORe
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:DELete
Save Immediate x
Stores the current instrument setting in one of the intermediate memories.
These instrument settings are retained until a different instrument setting is stored in
the intermediate memory. When the instrument is switched off, the contents of the
intermediate memories are retained.
Remote command:
*SAV on page 772
Exclude Frequency
The current frequency is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL on page 1043
Exclude Level
The current level is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL on page 1102
Recall
Restores the selected configuration.
During recall, the instrument considers all related settings, for example sweeps in
active state or lists. An error message indicates the settings which cannot be imple-
mented.
Remote command:
:MMEMory:LOAD:STATe on page 786
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI command:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:LOAD
Recall Immediate x
Loads the selected configuration from one of the intermediate memories. A message
appears if no instrument configuration is stored in this memory.
Remote command:
*RCL on page 772
File Manager
Accesses the "File Manager" dialog, see Chapter 10.8, "Using the File Manager",
on page 639.
10.4.2 How to Save and Recall Instrument Settings
Instrument settings can be saved to a file and loaded again later, so that you can
repeat the tests with the same settings.
Saving and Recalling Instrument Settings
To Next Page
Loading...
