Rohde & Schwarz SMW200A - Multi-Carrier Commands

Remote Control Commands
R&S
®
SMW200A
943User Manual 1175.6632.02 ─ 16
Parameters:
<Filename> string
Example: see Example "Creating a multi-segment waveform" on page 922
Manual operation: See "New List" on page 332
Multi-Carrier Commands
Required options
See Chapter 4.9.1, "Required Options", on page 355.
[:SOURce<hw>]:BB:ARBitrary:MCARrier:PRESet
Sets all the multi-carrier parameters to their default values.
Example:
SOURce1:BB:ARBitrary:MCARrier:PRESet
Usage: Event
Manual operation: See "Set to Default" on page 358
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:CATalog?
Queries the available settings files in the specified default directory. Only files with the
file extension *.arb_multcarr are listed.
Return values:
<Catalog> string
Example: See Example "Generating a multi carrier signal" on page 926
Usage: Query only
Manual operation: See "Save/Recall Frame" on page 359
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:LOAD <Filename>
Loads the selected file from the default or the specified directory. Loaded are files with
extension *.arb_multcarr.
Setting parameters:
<Filename> "<filename>"
Filename or complete file path; file extension can be omitted
Example: See Example "Generating a multi carrier signal" on page 926.
Usage: Setting only
Manual operation: See "Save/Recall Frame" on page 359
SOURce Subsystem