Rohde & Schwarz SMW200A - Page 937

Remote Control Commands
R&S
®
SMW200A
922User Manual 1175.6632.02 ─ 16
// the first 200 samples of the current waveform will be output after
// the next trigger event
// SOURce:BB:ARBitrary:TRIGger:SEQuence ARETrigger
// SOURce:BB:ARBitrary:TRIGger:SOURce EGT1
// external trigger signal must be provided at the USER connector
// SOURce:BB:ARBitrary:TRIGger:EXTernal:SYNChronize:OUTPut ON
// SOURce:BB:ARBitrary:TRIGger:EXTernal:DELay 200
// SOURce:BB:ARBitrary:TRIGger:EXTernal:INHibit 100
// SOURce:BB:ARBitrary:TRIGger:SOURce INTB
// the internal trigger signal from the other path must be used
// SOURce:BB:ARBitrary:TRIGger:OBASeband:DELay 25
// SOURce:BB:ARBitrary:TRIGger:OBASeband:INHibit 10
SOURce:BB:ARBitrary:TRIGger:SEQuence AAUTo
SOURce:BB:ARBitrary:TRIGger:SOURce INTernal
SOURce:BB:ARBitrary:STAT ON
SOURce:BB:ARBitrary:TRIGger:EXEC
Example: Specifying delay and inhibit values in time units
The following example lists the commands necessary to configure the instrument as
described in "Specifying delay and inhibit values in time units" on page 243.
SOURce1:BB:ARBitrary:CLOCk 1000000
SOURce1:BB:ARBitrary:TRIGger:SEQuence AAUT
SOURce1:BB:ARBitrary:TRIGger:SOURce EGT1
SOURce1:BB:ARBitrary:TRIGger:DELay:UNIT SAMP
SOURce1:BB:ARBitrary:TRIGger:EXTernal:DELay 100
SOURce1:BB:ARBitrary:TRIGger:EXTernal:RDELay?
// Response: 100
SOURce1:BB:ARBitrary:TRIGger:DELay:UNIT TIME
SOURce1:BB:ARBitrary:TRIGger:EXTernal:TDELay 0.00001
SOURce1:BB:ARBitrary:TRIGger:EXTernal:RDELay?
// Response: 0.00001
SOURce1:BB:ARBitrary:TRIGger:DELay:UNIT SAMP
SOURce1:BB:ARBitrary:TRIGger:EXTernal:DELay 10
Example: Creating a multi-segment waveform
The following example lists the commands necessary to create a multi-segment wave-
form.
// ******************************************************************
// Reset instrument first
// ******************************************************************
*RST; *CLS
// SOURce:BB:ARBitrary:PRESet
SOURce Subsystem