Signal Routing and System Configuration
R&S
®
SMW200A
161User Manual 1175.6632.02 ─ 16
Remote Control Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select
"Remote Control".
In this dialog, you can send individual SCPI commands or a sequence of SCPI
commands to the connected instruments.
The sent commands and their results are displayed in the "Command Trace" field, as
long as the trace is not deleted "Clear Trace". The sent commands are also listed in
the "History" list. As long as this history list is not deleted ("Clear History"), you can
select a command from the list and send it again.
See also:
●
"To create a remote control sequence or modify the initialization sequence"
on page 207
●
Example "Controlling the R&S SMW and external RF instruments with the same
application program" on page 829.
Settings:
Mode........................................................................................................................... 162
Command, Send Command........................................................................................162
File, Sequence, Send Sequence.................................................................................162
History, Clear History.................................................................................................. 162
Commands Trace, Clear Trace...................................................................................162
System Configuration Settings
To Next Page
Loading...
